Competitive Advantages

Lateral Kettles with heat exchangers provide for:
A.) 20 times more heated surface area than competitive designs. Heat far more material with 1/4 the temperature.
B.) Material loads at your feet, not 12’ in the air.
C.) Low center of gravity for even weight distribution.
D.) Unlike vertical melters, horizontal mixers lift & smear cold material vertically over the walls of the kettle thereby melting material quickly even when kettles are empty.
E.) Kettles extend all the way to the rear of the truck eliminating much of the plumbing formerly associated with thermoplastic trucks. There is no plumbing between the Kettle & prescreen, knife valve, Hog Pump, final filter & gun hoses.
F.) Our helical mixer design forces material to smash & mix rather than allowing it to travel in circles in a solid clump for hours.

The Thermo Hog uses 500°F oil NOT 2000°F direct-fired flame. This results in no charred or scorched material & zero shutdown time.

The Thermo Hog uses just one burner, NOT 9 burners found on competitive equipment.

Just two hot oil pumps.

The Thermo Hog uses only 2 kettles, NOT 4-kettle configurations offered by competitors.

Kettles can be continuously fed up to 10,000 lbs. of material per hour without a decrease in temperature.

Laterally-stowed kettles allow for exceptional weatherproof insulation.

One hour start-up time from one day to the next.

Very low “cold core diameter”: 11 inches max VS 36” or more on competitive designs. This radically improves cold start-up times after a long weekend.

Hog speed control automates speed with no modifications to the truck's driveline.

Hog Pumps vs Roper pumps. Much easier & less costly to rebuild. Our pumps do not force glass against gears which will crush the beads. Instead, our Hog Pumps have ample clearance for beads to pass.

Spray, extrude & profile guns are available.

Pointer bar, laser, and or Camera with crosshair generator.

Videos of the Thermo Hog TH16 Applications

The Thermo Hog TH16 is revolutionizing the pavement marking industry. Through its innovations, stripers are saving time and money while increasing quality and performance!

Technical Specs

Kettle Size8,000 lbs. (3,628.7 kg) per color
Melting Rate12,000 lbs. (5,443.1 kg) per hour per melter
Material Deck24,000 lbs (7,527 kg)
Burner1.4 million BTU
Speed Control2-10 MPH (3-16 KPH)
Heat ExchangersTwo 200 ft² (18.6 m²) with 5/8” (1.27 cm) steel tubes
Hog Pumps2 high-volume Hog Pumps
Air Compressor280+ CFM
Bead Tank2x 4,000 lbs. (1,814 kg)

Request the Thermo Hog TH16 Specification Sheet

Get the Thermo Hog TH16 specification sheet that you can print and save to your computer for review at any time. A great tool for model comparisons and for comparing the Thermo Hog TH16 to other manufacturer's equipment. Specification sheets contain:

  • Complete Model Specifications
  • List of Model Options
  • List of Model Applications
Thermo Hog TH16 Spec Sheet