The Rumble Hog is a 3-in-1 machine that can Grind pavement markings, Groove pavement for inlaid markings, and cut Rumble Strips.
The Rumble Hog uses 1" (2.5 cm) diamond-tipped teeth for longer durability and higher efficiency.
The Rumble Hog has the option to be fitted with a Scissor Lift High Dump for easy dumping of debris.
Computer Controlled Profiling Package comes standard to provide the ability to perform sinusoidal rumble cuts, plunge cuts, and recessed marker profiles. These profiles can be customized to any specification.
The Rumble Hog can Grind and cut Rumble Strips up to 5 mph (8 kpm). It can Groove up to 3.5 mph (5.6 kpm).
In-cab PLC control gives you the ability to program cutting patterns easily.
The rear-mounted drum is capable of shifting from one side of the truck to the other by use of a simple joystick control located in the cab.
The Rumble Hog includes a bumper extension that allows the cutter drum to extend an additional 12 inches past either side of the truck. This allows the operator to keep the truck centered in its lane while making cuts to the center or edge lines on the road. Only one extension is needed as it can be deployed on either side of the truck. It is easily removed and reset using two pins.
The Rumble Hog has an additional cutting package available that will allow for sinusoidal wave and plunge cuts!
The Scissor Lift High Dump extends 12’ into the air and allows you to easily dump debris on the side of the road, into a dumpster, or at a designated location.
Cutting package is available for sinusoidal wave.
Get the Rumble Hog specifications sheet that you can print and save to your computer for review at any time. A great tool for model comparisons and for comparing the Rumble Hog to other manufacturers equipment. Specifications sheet contains:
